Loading
filterfilterClose entries
filterfilterFilter entries

Knowledge transfer


Current

Reduction of green house gases by process innovations in the primary Industry, SP 6: Development of a methodology for cross-project and ecological potential assessment, cement industry

The transfer and networking project ReInvent aims to provide technical and organisational support for the BMBF funding measure KlimPro-Industrie.

Learn more

Completed

BetonQuali - information and qualification platform

"BetonQuali - information and qualification platform", a joint project of VDZ gGmbH and its project partners, aimed to develop and test a training method for semi-skilled and unskilled employees in the concrete industry.

Learn more

Completed

Increasing energy efficiency in the cement industry through training by means of virtual reality (VR)

The aim of IGF project 21619 is to develop a training simulator with which learners can independently solve typical process engineering tasks within a virtual reality (VR) environment, particularly in connection with ball mills.

Learn more

Cement production


Completed

Reducing mercury loads in rotary cement kilns using sorbents

The research project was investigating the extent to which the different types of mercury bond, the alkaline atmosphere and high dust loading influence the effectiveness of possible additives such as activated charcoal, open-hearth coke or other calcium compounds and mixtures of these.

Learn more

Completed

Development of a high-efficiency SNCR process with staged combustion for reducing NOₓ and NH₃ emissions in cement industry rotary kiln plants with precalcination

The aim of the research project was to obtain general NOₓ emission abatement to 200 mg/m³ with a minimal NH₃ slip of max. 30 mg/m³ in cement industry rotary kiln plants with precalcination.

Learn more

Completed

CEMCAP – CO₂ capture from cement production

Taking into account the experimental results and a techno-economic analysis, CEMCAP has developed a decision basis for CO₂ capture technologies in the cement industry. This should enable European cement producers to perform plant-specific CCS economic analyses and adapt to a world with limited carbon emissions. From a European perspective, CEMCAP aims to expand the portfolio of cost- and resource-efficient options for CCS and thus the possibilities for reducing greenhouse gas emissions.

Learn more

Completed

Increasing energy efficiency in the cement industry through training by means of virtual reality (VR)

The aim of IGF project 21619 is to develop a training simulator with which learners can independently solve typical process engineering tasks within a virtual reality (VR) environment, particularly in connection with ball mills.

Learn more

Completed

Improving the selection and service life of metallic materials in the high-temperature range of rotary cement kilns, taking into account the relevant gas atmosphere

The aim of this research project was to investigate the issue of high-temperature corrosion in the hot area of the preheater and the rotary kiln.

Learn more

Completed

Investigation on the interaction of fuel particles and cement clinker with the aim of increasing the use of alternative fuels

The aim of the research project was to identify those fuel particles which potentially cause the greatest disturbances and to determine their rate of conversion in the flame and in the clinker bed. A further goal was to derive quality criteria for AF, to elaborate recommendations for the optimisation of fuel feeding systems and to develop a tool to estimate the suitability of an AF.

Learn more

Concrete technology


Completed

New functionalities of textile-reinforced concrete through titanium dioxide modifications Subsidiary project: fine-grained concrete and cement-bound adhesive

The working plan of the Research Institute of the Cement Industry was aimed at systematic investigation of the mix formulation and workability of a nano-based cement-bound adhesive.

Learn more

Completed

ASR performance testing: extending the database to include the 60 °C concrete test with particular reference to cements with several main constituents

In the IGF (Cooperative Industrial Research) project the framework conditions for a possible performance test method for evaluating the alkali reactivity of concrete was calibrated on the basis of the requirements of the German regulations.

Learn more

Completed

Reducing the environmental impact of concrete construction through new types of cement and the concrete produced from them using starting materials that are available in adequate quantities

The aim of this research project was the laboratory and industrial production and testing of cements that contain levels of limestone above the maximum content described in DIN EN 197-1.

Learn more

Completed

Procedures for E II aggregates

VDZ and the Brandenburg Technical University Cottbus-Senftenberg (BTU) investigated whether it is possible to define an alkali sensitivity class E II-S on the basis of the 40 °C concrete test with cloud chamber storage. In addition, criteria for the rapid test procedure and the 60 °C concrete test as well as the BTU-SP rapid test were also derived.

Learn more

Completed

Determination of characteristic values based on the degree of hydration for predicting the durability of concrete

Mortar and concrete trials were used to determine characteristic parameters, such as the void filling of the cements, their hydration characteristics, the porosity of the mortars and concretes made with these cements, and the durability of the concretes.

Learn more

Completed

Boundary conditions for accurately achieving projected concrete properties in the modern 5-material system of diverse concrete constituents

Within the framework of the research project, the intention was to identify the most important influence parameters that are responsible for showing unscheduled properties such as changed consistency, signs of sedimentation, or an accelerated or decelerated strength development in certain cases of fresh concretes which are produced over prolonged periods.

Learn more

Chemistry and mineralogy


Current

Performance of ternary cements with Portland cement clinker, calcined clay and limestone as the main constituents

The project systematically investigates the performance and hydration behaviour of ternary cement (KQL) with clinker (K), calcined clay (Q) and limestone (L) as well as key durability aspects of concretes produced with these materials.

Learn more

Current

Systematic application of IR spectroscopy to strengthen the circular economy in the construction industry

In this research project, IR spectroscopy in combination with mathematical tools (chemometrics) is going to be evaluated as an analytical method for the characterisation of silica based materials, primarily X-ray amorphous materials, with regard to the reliable determination of the composition of material mixtures with X-ray amorphous materials (e.g. ternary cements with calcined clay and/or recycled concrete fines). In a next step, the findings on the analytical method and evaluation routines developed for cement are going to be evaluated with regard to their transferability to siliceous aggregates for estimating its alkali sensitivity.

Learn more

Current

Process atmosphere during clay calcination – effects on emissions and product properties

Calcined clays as the main cement constituent are an essential part of the cement industry's decarbonisation strategy. Many clay deposits have iron-rich impurities that form hematite during calcination, which colors the product, the cement and ultimately the concrete red. A reducing atmosphere during calcination and/or cooling can prevent the formation of hematite. Systematic findings on the influence of secondary constituents in clays on their reactivity, emissions and cement-technical properties have hardly been available to date and are to be systematically investigated in the project.

Learn more

Current

High-quality recycling of crushed concrete sand

In the ZIM research project, used concrete is processed in such a way as to improve the usability of all fractions generated, in particular the crushed sand and the fine fraction. To this end, tests are also being carried out on the pozzolanic reactivation of the recycled concrete fines.

Learn more

Current

X-ray analysis for production control of cements with calcined clays

The subject of the IGF research project 22502 N is the application of X-ray diffraction analysis for production and quality control of calcined clays and cements produced with them, in order to accelerate the development of cements with further reduced clinker content within the framework of the decarbonisation of the cement industry.

Learn more

Current

Elution of fresh concrete – determination concept

The IGF research project 22330 N is concerned with the environmental compatibility of cement-bound building materials in special application situations in which the binder comes into contact with groundwater during the processing phase. A procedure is being developed to demonstrate the environmental compatibility of the building materials in these situations as well.

Learn more

Environmental protection


Current

CaLby2030 – Calcium Looping to capture CO2 from industrial processes by 2030

In CaLby2030, the deployment of Calcium Looping technology (CaL) using Circulating Fluidised Bed reactors (CFB) in the cement industry will be investigated, aiming at efficient CO₂-Capture without compromising clinker production or product quality. A technology scale-up will be also evaluated in a German cement plant by exploring different retrofit possibilities. Besides the cement sector, the deployment of CFB-CaL technology in other relevant sectors will also be investigated.

Learn more

Narrow down your search here.

Areas

  • Publications
  • Research projects
  • Training
  • Events

Subjects

  • All
  • Knowledge transfer
  • Cement production
  • Cement industry
  • Concrete technology
  • Chemistry and mineralogy
  • Quality assurance
  • Environmental protection

Languages

  • All
  • English

Thank you for your interest in our publication:

Loading